Kawasaki Z125 Forum banner

Diy intake.

157 Views 0 Replies 1 Participant Last post by  Clucht1976
So I put a 15t on to correct the speedo but could never hit rev limit with it.
I tried a 3d printed intake and it made a big difference but didn't like the look of all the parts required.
I re designed it totally except for the intake hole and cut it out in wood with my laser engraver.
I can hit rev limit so fast now.
Only mods are my new intake and a Kawasaki brad o2 delete.
I will be redoing the intake hole bigger on v4.
Also I made a back plate for this v3 one so I can run another filter where the white part that says uni is so dual filters down the road once I get another sheet of uni.
Motor vehicle Green Automotive lighting Hood Automotive tire

Automotive tire Motor vehicle Automotive exterior Font Bumper

Guitar accessory Wood Musical instrument accessory Music String instrument accessory

Sleeve Font Material property Pattern Publication

Motorcycle Automotive lighting Green Automotive tire Automotive fuel system
See less See more
1 - 1 of 1 Posts
1 - 1 of 1 Posts